Front-Panel Extension, 30 cm, Single Sleeves Discontinued | |
| More variations available Show | |
Nanoxia Front-Panel Extension, 30 cm, Single Sleeves
The Nanoxia Front Panel extension cable - From their high quality sleeved cable series
Features
- Extends the reach of your front panel connectors
- High quality, individually sleeved cables
- Braided cables help achieve a neat cabling solution for the internals of your PC
This front panel extension set of cables originates from the Nanoxia sleeved cable series. Each cable is 30cm long and the individual wires are covered with black nylon braided sleeves.
This type of extension cable is typically used to extend the computer cases front panel motherboard connectors as well as helping to improve the overall tidiness inside the PC.
| Specifications | Front-Panel Cables |
|---|---|
| Cable Type | Front panel extensions |
| 3-pin Cable | Speaker |
| 2-pin Cables | Power SW, Reset SW,+P LED, -P LED, HDD LED |
| Length | 300 mm each |
| Colour | Black |
| Warranty | 24 months |
| EAN barcode | 4260285290282 |
| Specifications | Front-Panel Cables |
|---|---|
| Cable Type | Front panel extensions |
| 3-pin Cable | Speaker |
| 2-pin Cables | Power SW, Reset SW,+P LED, -P LED, HDD LED |
| Length | 300 mm each |
| Colour | Black |
| Warranty | 24 months |
| EAN barcode | 4260285290282 |
Product Resources
Top Cables and adapters
Gelid PWM Adaptor Cable for VGA Cooler Fans
Quiet PC IEC C13 UK Mains Power Cord, 1.8m (Type G)
Streacom PCI Express 1X Slot Riser Card Adapter Cable
Noctua NA-SYC1 4-Pin PWM Fan Y-Cables, 2 pack
Noctua NA-SEC1 4-Pin PWM Fan Extension Cables, 3 pack
Quiet PC IEC C13 Euro Mains Power Cord, 2m (Type F)
Noctua NA-SRC10 3-Pin Low-Noise Adaptors, 3 pack
Noctua NA-SRC7 4-Pin PWM Low-Noise Adaptors, 3 pack
Noctua NA-SYC2 3-Pin Fan Y-Cables, 2 pack
Quiet PC Cloverleaf C5 UK Mains Power Cord, 1.8m
Recently Viewed Products
“Perfect silence”
“Excellent fan. Very quiet. Fixing to the CPU, an AMD 4350, presented a problem as the plastic bezel did not want to move. However I just removed the non stick silicon rubbers from the back and stuck in place with a small amount of impact glue at each corner. The results perfect and quick. (easily removed for servicing). No increase in noise level was noted on the removal of the silicon mounts. The fan cools adequately for my needs but would be marginal for a power user on this CPU.”